plastic key card sleeves Heavy Duty Horizontal Permanent Locking Badge Holder

plastic key card sleeves Heavy Duty Horizontal Permanent Locking Badge HolderThe 1840 6040 is a clear horizontal badge holder with a snap lock mechanism. Once the badge is inserted and the end piece snapped into place, the holder is designed to be very difficult to open. There is no key. The badge and holder are intended to stay together permanently. The completely clear polycarbonate construction allows both sides of the badge to remain visible at all times. Holds two standard 30 mil CR80 cards or one thicker proximity card

The 1840-6040 is a clear horizontal badge holder with a snap-lock mechanism. Once the badge is inserted and the end piece snapped into place, the holder is designed to be very difficult to open. There is no key. The badge and holder are intended to stay together permanently.

The completely clear polycarbonate construction allows both sides of the badge to remain visible at all times. Holds two standard 30 mil CR80 cards or one thicker proximity card in horizontal orientation. Insert size 3-3/8" x 2-1/8" (86 x 54mm). Slot hole and chain holes for lanyard or badge reel attachment. Proximity card functionality works normally from inside the holder.

Note: This holder does not use a guard key. If you need a holder that can be opened and relocked with a key, see the 1840-6630 locking badge holder. The 1840-6040 is a direct substitute for JAM part number IDS-92H. For vertical orientation, see the 1840-6045.